Want to Know About HAARP and Weather Modification? Want to Prove it to a Non-Believer?
Don't miss the Discovery Channel piece on geoengineering and chemtrails for more powerful information. Link. - W.E.
For anyone still “on the fence” about weather modification / manipulation:
All links below should satisfy MOST questions: Save the pdf’s before they’re gone for good from the net!
Scalar RADAR and its effects:
US Navy involved:
Link between HAARP earth-penetrating tomography technology and earthquakes.Posted by PC Latest news, World newsSunday, March 13th, 2011
The High-frequency Active Auroral Research Program (HAARP) is a congressionally initiated program jointly managed by the U.S. Air Force and U.S. Navy. The United States Congressional records show that HAARP is funded by the US government. The U.S. Senate set aside $15 million dollars in 1996 (Clinton administration) to develop the ability to penetrate the earth with signals bounced off of the ionosphere. This earth-penetrating-tomography has since been developed and used by the US government to look inside the planet to a depth of many kilometers in order to locate underground munitions, minerals and tunnels. The problem is that the frequencies used by HAARP for earth-penetrating tomography is also within the frequency range most cited for disruption of earth’s own electromagnetic field.————————————————–
HAARP patents states that HAARP can beam radio energy into the Auroral electrojet, the curved, charged-particle stream formed at high latitudes where the solar wind interacts with Earth’s magnetic field. The radio energy then disperses over large areas through ductlike regions of the ionosphere, forming a virtual antenna that can be thousands of miles in length.
Such an ELF antenna can emit waves penetrating as deeply as several kilometers into the ground, depending on the geological makeup and subsurface water conditions in a targeted area. HAARP uses ground-penetrating radar (GPR) to beam pulses of polarized high-frequency radio waves into the ionosphere. These pulses can be finely tuned and adjusted so that the bounced ground penetrating beam can target a very specific area and for a specific length of time. Beaming a very large energy beam into the ground for an extended period can cause an earthquake. After all, an earthquake is the result of a sudden release of energy in the Earth’s crust that creates seismic wave resonances. The same array of antennas that are used by HAARP for ground penetrating tomography can also be used to penetrate deep into the ground and cause an earthquake anywhere around the World.
Geophysical events like earthquakes and volcanic eruptions – the kinds of things that may already be on the edge of discharge – can, with the right resonant energies added into the system, cause them to overload and actually fracture. Former U.S. Secretary of Defense William S. Cohen actually made the statement regarding weapons of mass destruction and the idea of generating earthquakes artificially. In a April 28, 1997 DoD News Briefing at the Conference on Terrorism, Weapons of Mass Destruction, and U.S. Strategy at the Georgia Center, Mahler Auditorium, University of Georgia, Athens, Ga. Cohen stated: “Others are engaging even in an eco- type of terrorism whereby they can alter the climate, set off earthquakes, volcanoes remotely through the use of electromagnetic waves.”
United States Patent 5041834 – Artificial ionospheric mirror composed of a plasma layer which can be tilted.
METHOD AND APPARATUS FOR ALTERING A REGION IN THE EARTH’S ATMOSPHERE, IONOSPHERE, AND/OR MAGNETOSPHERE
the USGS seeding the clouds to make it snow:
A few of the weather modification COMPANIES in operation today inside the USA:
This below is a cloud seeding generator:
Here is a very long list of links, pdf files from institutions like stanford, leicester university, cornell, University of Mass., etc.. and from several military and .gov sites
some links work, others are “down” but still included to prove they DID exist. These things have a way of disappearing off the net, so download them and MIRROR them on other file sharing sites if you can.
Ionospheric Heating using frequency – Earth Penetrating Tomography using ground based stations:
Defense Secretary from the 1990′s William Cohen speaking on the subject of HAARP –
US Navy electronic warfare :
Lower ionosphere heating / geometric modulation / circle sweeps, sawtooth sweeps, square wave, rectangle wave:
Stanford VLF AWESOME network:
Websites of each known facility:
Sura Ionospheric Heating Facility
The EISCAT Associates
Their Facility -
EISCAT Headquarters are located at Kiruna in Sweden
The EISCAT Scientific Association,
PO Box 812,
S-981 28 KIRUNA
cloud seeding generator pictured on the NAIWMC website:
VLF and VHF station location websites:
Arecibo, Puerto Rico
Millstone Hill, USA
Pic of Haystack facility and more info:
(search for scatter)
The Institute possesses a complex of unique astrophysical equipment deployed in the Sayan Mountains, especially the Siberian solar radiotelescope, a large solar vacuum telescope, an incoherent scatter radar, as well as a network of astrophysical laboratories throughout the territory of Siberia.
Upper Ionosphere changes HF (high frequency) into ULF (ultra low frequency)
In essence.. this shows that one can send a HF (high frequency) signal into the upper ionosphere with HAARP, and it “transforms” into a ULF ultra low frequency… and vice versa.. a LOW frequency modulates into the HIGH frequency!
here is the link to the “Efficiency scaling” HF transformation into ULF/VLF/ELF via the ionosphere.
Another link on MU, Japan
picture below of “chemtrails” i.e. aerosols sprayed from airplanes to induce or aid in frequency manipulation of the cloud environment:
USA (Besides HAARP)
HIPAS — High Power Auroral Stimulation Observatory
Located near Fairbanks Alaska
ULCAR stations :
Papers, .pdfs, and documents regarding various aspects of frequency and weather modification:
CERN and HAARP –
Books and older publications covering weather modification:
These shots below come from a Navy .mil website .. clearly showing a “HAARP ring / Circle sweep” pattern and circumference similar to that which we are seeing on RADAR — only MUCH more powerful — covering the entire state of Alaska.. done using electromagnetic modulation from a ground based station.. VLF and UHF.
“By modulating the ambient current flowing in the ionosphere, e.g., the auroral electrojet, it is possible to generate extremely low frequency (ELF) and very low frequency (VLF) radiation. This ionospheric modification technique can provide such waves for probing both the Earth and the ionosphere- magnetosphere. The modification occurs in the lower D-region and can provide information about the ambient conditions in one of the least diagnosed regions of the ionosphere.
The electrojet is modulated by using a high frequency heater (a few MHZ) with the power modulated at the desired ELF/VLF frequency to heat the ionospheric electrons in the lower D-region. Figure 1a shows a sketch of the heater and heated region. The heated region is typically at 75 km (though this depends upon the carrier frequency) and can be 30 km in diameter and a few km thick. Viewed from above (see Figure 1b) the heated region is a roughly circular patch. The smoothness of the heated region depends upon the antenna radiation pattern as well as D-region conditions. The heating increases the electron-neutral collision rate which changes the conductivities. Since on ELF time scales the ambient electric field is constant, modulating the conductivity produces a current modulated at the same frequency. At these altitudes the conductivity change is predominantly in the Hall conductivity. If the ambient electric field, E, is in ±y direction, a time varying current perturbation is generated, j, in the ±x direction (Fig. 1b). The time varying current launches waves both up and down the Earth’s magnetic field. In the simulations shown here, we start with a time-varying current and study the downward propagating waves and how they couple into the Earth-ionospheric wave guide.
The animations show 5 different representations of the same simulation. The simulation uses a time-varying current perturbation (1 kHz) in the D-region at 75 km. The current is in the magnetic east-west direction. The Earth’s magnetic field is vertical. The simulation box is 1800 by 1800 by 120 km. Isosurfaces are shown for the absolute value of the horizontal magnetic field ABSB and of the vertical electric field ABSEZ. Also shown is the east-west magnetic field in the near-field BX1 and in the far-field BX2. Since the field amplitude falls off with distance, BX1 uses a order-of-magnitude larger isosurface value than BX2 to emphasize the field close to the site. The north- south magnetic field is shown in BY1 and BY2. These plots look slightly different from the absolute value plots where both the positive and negative surfaces were shown. Also BX and BY do have a different orientation of the their radiation patterns. The direction of the radiation is determined by the total horizontal field shown in ABSB and by the vertical electric field shown in ABSEZ. The radiation pattern in the earth-ionosphere waveguide is a combination of a linear dipole antenna and a right-hand circular antenna. At ELF frequencies because of low D-region absorption the dipole is dominant. The dipole radiates in the magnetic east-west direction.
Because 1 kHz is below cutoff the mode in the waveguide is a TEM mode. The mode consists of a horizontal B field perpendicular to the direction of propagation and a vertical electric field. With perfect conductors, the mode is uniform in the vertical direction. As the wave propagates in the waveguide, the top of the wave is approximately at the bottom of the ionosphere. Above the heated region, waves are also launched along the Earth’s magnetic field. In the near-field ( BX1 and BY1) one can see the pulse being radiated downward. It strikes the ground and reflects back up to the ionosphere. Part of the energy propagates up the field lines into the ionosphere. This is the bubble seen rising up. The D-region is highly collisional and damps this wave. Looking at BX2 and BY2 one can see that the energy mainly stays in the waveguide. If one looks closely at the top of the wave in the waveguide the wave appears to be curved. The waveguide mode is coupling into the bottom of the D-region and driving a whistler mode up the field lines. The whistlers have a much lower velocity than the waveguide mode and can only propagate along the field lines. This acts to curve the top of the waves. These waves help form the bubble that propagates up the field line. Because of this, the diameter of the bubble is much larger than the heated region.
Above the heated region in ABSEZ one can see a pair of coils revolving around each other. These are the currents that flow up and down the Earth’s magnetic field forming the current loops associated with the waves propagating up the field lines. Finally, EZ1 is a blow-up of the high-altitude portion of the vertical electric field for positive values of the electric field; the current loop is more clearly seen.”
More .pdfs and information on weather modification via frequency and aerosols:
Continue for more information